Click here for the original Crumb Cake version as shown below... with which I used different paper patterns too...
And the Tutorial for you... apologies for the delay... as a lot of you were asking for this one... Please note that the photos used in the Tutorial below are from a different card variant/colourway... but as they still help explain the words... I've left them in!
But I do suggest that you visit this standard Pop Up Centre Step Panel Card Tutorial first... and maybe make one of those to start off with... as the step by step photos correspond in that version... and these cards are very easy once you know what you are doing!!
Craft Spa Recipe
Main Card - A4 Card Whisper White 10.5cm x 24cm (US Letter 4 1/4" x 9 3/4")
Front Panel - A4 Card Whisper White/Crumb Cake 11 x 6cm (US Letter 4 3/8" x 2 3/8")
Roof - A4 Card Whisper White/Crumb Cake 7 x 3cm (US 2 3/4" x 1 1/4")
Roof - A4 Card Whisper White/Crumb Cake 7 x 3cm (US 2 3/4" x 1 1/4")
Card Back - Birds Paper 10 x 8.5cm (US 4" x 3 1/4")
Card Base – Flowers Paper 10 x 5cm (then cut LANDSCAPE to Top 2.5cm & 2.5cm Front/Bottom) (US 4" x 2" - cut 1" Top & 1" Bottom)
Front Panel –Pink Polka Dot Paper 5.8 x 8.5cm (US 2 1/4" x 3 3/8")
Craft Spa Tutorial
1. Score largest Whisper White panel LANDSCAPE at 12,15,18 & 21cm (US Letter 4 3/4", 6", 7 1/4" & 8 1/2")
2. Score smaller Crumb Cake/Whisper White panel LANDSCAPE at 1 & 4cm (US Letter 3/8" & 1 5/8")
TIP - easiest to score LANDSCAPE at 1cm (US 3/8") to right hand side (RHS) on Top Bar...
Then turn 180 degrees (ie so that the RHS becomes the LHS!) and score LANDSCAPE at 4cm (US 1 5/8")TIP - easiest to score LANDSCAPE at 1cm (US 3/8") to right hand side (RHS) on Top Bar...
3. Mountain bone fold all score lines
4 Fold up the base of the larger Whisper White card panel to create the front step (like a box section)
5 Apply glue to last/end section (ie on the back!)
6 Fold up flat to stick ie TIP - height of card should be smallest option so it will fit in a standard envelope! When this is flat... you should have 2 sections to the front and 2 to the back...
7. Adhere papers as necessary
PLEASE NOTE THAT ON THIS VARIANT... I STUCK THE FRONT PAPER ONTO THE BASE SECTION AFTER I HAD ASSEMBLED THE CARD WHEREAS THE CARD/PHOTOS in steps 8-16 SHOW THE PAPER ALREADY STUCK ON!
PLEASE NOTE THAT ON THIS VARIANT... I STUCK THE FRONT PAPER ONTO THE BASE SECTION AFTER I HAD ASSEMBLED THE CARD WHEREAS THE CARD/PHOTOS in steps 8-16 SHOW THE PAPER ALREADY STUCK ON!
9. Apply glue to last/thin "glue tab" section
10. Fold up card base/step so that height is smallest option!
Line up 2nd score line to top of back of main card (ie you have 2 sections folded to the back - not one as would [normally] be more logical!!)
And so that front panel is central to left and to right...
Line up 2nd score line to top of back of main card (ie you have 2 sections folded to the back - not one as would [normally] be more logical!!)
And so that front panel is central to left and to right...
11. Stick
12. Apply pressure along the glue tab to adhere firmly...
13. Fold up card base/step so that height is smallest option!
14. Work out where you need your glue on the front panel at the bottom of the card!
15. Apply glue where needed (ie under the line of the bone folder!)
... or more importantly not where it it is not needed! (ie above the line of the bone folder!)
16. Fold front panel down flat to stick...
17. Now adhere that front Base Paper...
18. Decorate as necessary
The roof and polka dot papers are cut using the Nested Stitched Label dies... (c. 2 1/2" & 2" high respectively) and then the stitched straight line die placed across and re-run through the Big Shot. Note that this die does not cut... it just adds stitches... but you can then just trim with your Paper Snips scissors as required...
The roof and polka dot papers are cut using the Nested Stitched Label dies... (c. 2 1/2" & 2" high respectively) and then the stitched straight line die placed across and re-run through the Big Shot. Note that this die does not cut... it just adds stitches... but you can then just trim with your Paper Snips scissors as required...
The birds are cut from Bird Ballad papers...
Notes
(1) Don't stick anything that will go underneath the bottom of the card... It needs to be flat to stand up...
(2) I recommend that you have an envelope to hand to make sure everything is stuck on so that the card fits in your envelope. Especially if you are using a US medium (A2) envelope as you have less height than we do with our C6 envelope...
Notes
(1) Don't stick anything that will go underneath the bottom of the card... It needs to be flat to stand up...
(2) I recommend that you have an envelope to hand to make sure everything is stuck on so that the card fits in your envelope. Especially if you are using a US medium (A2) envelope as you have less height than we do with our C6 envelope...
And yes it does fold flat to post!
Amanda's Quick Links
Just click on the relevant pictures below for On Line Store, Catalogues and/or more information...
If you are ordering today... please add the Host Code shown below to earn yourself a gift... For orders over £150 you should claim your own Stampin Host Rewards... you will still get a separate gift from me...
|
Current Catalogues & Extra Products
THANK YOU ANGELA FOR THE TUTORIAL, I APPRECIATE YOUR TIME AND EFFORTS
ReplyDeleteMy pleasure Ann... hope you enjoy making one (or two!)
Delete